缅北强奸

• Service workflow :

1. The customer send service request to Lan.Liu [at] mcgill.ca, including objective, type of MS analysis, number of samples, preferred MS instruments, esdablished LC-MS or GCMS method if have,听etc.
2. The MMSP staff arranges a meeting with the customer to discuss details of the project.
3. The MMSP staff provides an estimated quotation to the customer and get it approved by the customer's supervisor. The service rate is listed here.
4. The customer sends samples to corresponding MMSP staff.
5. The MMSP staff runs samples on corresponding instrument, processes data, and sends the report to the customer.
6. When the project is completed, the MMSP staff will send the听invoice to and charge the customer at actual cost for instrument usage and staff time.

听

• LC Sample submission:

听听听听听听 Samples should be submitted in solids in Eppendorf tubes or in electrospray compatible solvent (HPLC 听听听听

听听听听听听 grade, and/or Milli-Q water) in HPLC glass vials, free of detergent, involatile salts/buffers/acids, etc.

听

• GC/MS Sample submission:

听听听听听 The customer听should indicate the solvent used to dissolve the sample, and specify the GC conditions to use:

听听听听听 inlet听temperature, oven temperature programme, carrier gas, type of column, etc.

听

Contact us if you have question about the MS service and need special sample handling.

PLEASE NOTE: The MMSP cannot accept (bio)hazardous or听radioactive materials.

听